The tool did the job, despite the lack of clear directions, and saved me a ton of time and money compared to other alternatives. Once this connection is made, it’s only a matter of turning the puller handle clockwise until the ferrule is removed from the copper tubing. 1-48 of 583 results for 'compression ring removal tool' Results Price and other details may vary based on product size and color. Remove liquid from hardtoreach areas with a long, flexible intake tube that extends into deep and hardto-access tanks. This is necessary in order to properly screw the puller handle to one side of the copper fitting, and to screw the old compression nut to the other side of the copper fitting. Compression Tools for Rope and Wire Rope Sleeves and Stops. /rebates/2fp2fHusky-Faucet-Handle-and-Sleeve-Puller-412f311493722&. It took a small bit of jostling, but it did fit. /rebates/2fpd2fBrassCraft-1-2-in-Fitting-Removal-Tool2f999903519&252fpd252fBrassCraft-1-2-in-Fitting-Removal-Tool252f99990351926tc3dbing-&idlowes&namelowes&ra1. To do this, I fit the larger diameter end of the silver fitting into the tools’ copper fitting, so that I could use the combined tool components to push the small diameter end of the silver fitting into the copper tubing. Because my copper tubing was slightly deformed by the existing (old) compression fitting, I needed to persuade the smaller diameter of the silver fitting to fit inside the tubing. Steel jaws hook onto compression or die springs to facilitate installation and removal. The smaller diameter end of the silver fitting must be fitted inside the ½ copper tubing (note that it does not sit up against the outside the copper tubing, it must slide inside the tube). The two jaws attached to the puller handle are not required for ferrule removal, but they can be left in place on the tool handle in case you need to use them for pulling a faucet handle later. Both of the fittings that come with this tool (a copper colored fitting and a silver colored fitting) are required to be used with the puller to remove ferrules. Removes compression ring from pipe fast and easy. Fits all inch copper stub-outs and pipes and nothing smaller. The splitter bit cuts the compression ring with just a few slight turns. I had difficulty understanding how to connect the tool parts for use. Fits into tight places: behind a pedestal sink, a low profile one piece toilet, a washing machine outlet box, etc. I won’t repeat other comments about how to use the device but will point out the one thing that held me up, so that maybe I can save someone else some time. It worked like a charm after I spent about 20 minutes trying to figure out how this little tool works. I recently used this tool to remove ferrules for 4 compression valve fittings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |